Heat press is REQUIRED for these transfers, Cricut hand press or hand iron will not lead to high quality press.

Basic Instructions
1. Set heat press to 275-300 depending on your press. Start with a lower temp and increase if needed.
2. Pre-Press the material for 5 seconds to remove moisture.
3. Place your DTF transfer image side down into position on your material.
4. Heat press transfer for 10 - 15 seconds with medium to firm pressure.
5. Remove the material from the heat press with the transfer still attached and set aside until completely cooled.
6. After cooled completely, slowly remove film and repress for 5 - 8 seconds (with a teflon sheet or parchment paper to protect the design).

If the transfer is not fully adhered then please repeat step 4.

Tips | Suggestions
• Start with a lower temp and increase if needed.
• Pull the film off slowly, if the transfer is not fully adhered then repeat step 4.

Additional Information
• Wait 24 hours before first washing.
• Turn the garment inside out.
• Machine wash with mild detergent.
• NO bleach.
• Dry at a normal low dryer setting on household machines.
• Do not dry clean. Do not use fabric softener.

Instructions apply to the material only, please follow garment washing instructions as well.

Please use our instructions as a guide, but understand not every press is the same. You'll need to figure out the settings that work best for your press and material.